Year-Round Tubing
Even if the speed is over 100km / h, there is no risk of burn accident, and it has been installed nearly for 500 ski jump hills around the world, and the Everslide ski jumping hills are built for 2018 Winter Olympic Games in Pyeongchang Alpensia. In addition, shock absorbers for the prevention of fractures and bruises are put together under the Everslide elements and safety plates in case the tubes are overturned during the run.
It is highly durable against cold weather and strong ultraviolet rays, and extra-ordinarily long warranty time of 20 years is offered (10 years for front, and 10 years for upside down) excluding the cost for the re-installation.
Everslide is using the four season PVC floor system, of which requirements for the structure and safety are specified and approved by F.I.S. (Federation Internationale de Ski).
Since the cross section of the lane is shaped like a concave dish, the tube does not derail from the lane. When the tube hits the lane guide during the sliding, it turns and adds to the thrilling pleasure.
Since there is no risk of collision, safe sliding is possible with a width of 1.5M per lane, and the maximum number of people can be boarded at the same time in a narrow width. (In the case of a general sled without a lane, the safety clearance between passengers must be at least 2.0 m)
Everslide and Lane Guides can be manufactured in various colors, and full color LED can be embedded inside the semi-transparent Lane Guides to maximize the promotion effect at night.
The friction between the flooring and the tubes are reduced by a small amount of water coming through the misting spray nozzles inside of the laneguide pipes, hot surface of the slopes in summer is cooled effectively.
Because the water flows only on the slope surface, it is possible to enjoy a comfortable gliding without getting wet on the clothes.
All the water flowing on the slope after being sprayed by the drip watering are collected and reused after filtration. In summertime, the water consumption of the landing pool can be significantly reduced.
The 20mm thick PE foam under the landing pool absorbs shocks and prevents accidents when the Tubes are overturned and the passengers fall.
An ordinary concrete pool is required to repair the broken tiles or peeled paint every year. However, the landing pool made from high-strength PVC fabric does not require such repairs and can be ready for operation with just one sweep right before the summer season.
After summer, the landing pool is covered with the both-side coated plywood after assemblying the wooden truss system and the artificial turf is simply screwed on the plywood. The wooden truss system is constructed at site and each part is numbered for easy assembly.
The summer season with landing pool and the other seasons without landing pool require a completely different water treatment method, which can be integrated into one system for efficient management.
With the chlorine sensor installed, the water in landing pool always maintains a certain level of chlorine concentration. Since the drip water flowing on the slope surface also uses chlorine-sterilized water from the landing pool, it reduces the occurrence of green algae.
The water in landing pool is lost due to the the splash of water by the tube sleds dashing into the water, and when the level of the landing pool becomes low due to a lot of lost water, water is automatically supplied to maintain a constant level of water.
Since there are no delayed passengers on departure, the consequent departure time will be significantly shortened and the THRC (Theoretical Hourly Ride Capacity) increases drastically.
There is no need for a lot of manpower at the starting zone because there is no need for security personnel to push the children directly at departure.
Since all passengers depart at the same time, the stopping times are almost same. This reduces the number of crashes between passengers who stop earlier and passengers later.
Each lane is equipped with a drive shaft, and the emergency motor with controller is prepared for the emergency.
Built-in waterproof function for trouble-free operation even in extreme weather conditions with rainfall or snowfall . Various sensors are installed to prevent various safety accidents.
A quality polycarbonate wind tunnel combined with PVC windows can be installed as an option.
With the built-in Windows Tablet control panel, you can run all the functions of your moving belt and view all the notifications, including all kinds of the boarding records and error messages. If the tablet control panel is connected to the Internet, 24-hour of remote diagnostics and emergency control at headquarters in Italy available.
(Portable Artificial Snowmaker)
It is light enough to carry only by one hand, so you can move to wherever you want to make snow.
Operates with 220V single phase and 4.5kW of power consumption.
The high pressure water pump and air compressor are designed to operate over night without overheating. All connections are with quick change couplings for quick connection and disconnection. All the remaining waters inside the pump, hoses, snow gun are drained automatically by using the special kit supplied and to be connected to an air compressor.
